The ultra heavy kneading machine for the production of grout requires cutting function when passing through various fixed prefabricated components installed in the vessel wall and vessels. This cutting function causes many parts to vortex and diffuse outward, making it a new and high-density fine particle kneading machine grout production equipment. The kneading machine has good sealing, is very clean, easy to operate, convenient to maintain, and has a long service life. The composition of the rotation and revolution inside the kneading machine produces four types of flowability of powder in the equipment: thermal convection, cutting, external diffusion, and infiltration.

The mixing heat conduction, convective heat transfer (including devolatilization), and reaction of high viscosity fluid mechanics in kneading machine and sewing agent production equipment have been one of the scientific research areas in recent years. For low viscosity liquids, traditional push type, paddle type, and pressurized impellers can already solve the difficulties. Although anchor type and bar type impellers cover a wide range of viscosity, the actual pre plasticization effect of anchor type turbine is much worse than that of helical belt in the higher viscosity range. In the low viscosity range, its shear stress is insufficient, and the radial circulation system is also poor, and due to the larger propeller diameter to groove diameter.

During the entire application process of the ultra heavy kneading machine for the production of grout, if there is any abnormal noise from the kneading machine that has already been used, it is highly likely that it is due to problems with the mechanical components on the kneading machine. It may be that the coupling between the pump and motor is not connected to the same axis. If so, the coupling between the pump and motor must be found in the correct center again. Or if the coupling becomes loose, it is necessary to reinforce the coupling structure or replace it with a new one.

If there is an abnormality in the seismic equipment of the kneading machine, it is necessary to inspect and carry out structural reinforcement. If that does not solve the problem, new parts must be removed and replaced again. It will also be due to the valves in the provided oil pipeline being clogged with dirt or difficulties with the throttle valve of the valves. One of the reasons for noise is that the nozzle is very small, so it is necessary to check the cleaning valve or replace the appropriate components.

The selection of hydraulic oil for kneading machine sewing agent production equipment also requires careful selection. Hydraulic oil is scarce due to low oil volume or high viscosity of bottom pressure gear oil caused by oil temperature. Hydraulic oil also constantly corrodes internal components, leading to damage to internal components.