The kneading machine and sewing agent production equipment are ideal machines for pre molding, mixing, vulcanization, and re healing of low viscosity, elastoplastic raw materials. The kneading machine and sewing agent production equipment can be used to produce and manufacture silicone, sealants, hot melt adhesives, food adhesives, pharmaceutical and traditional Chinese medicine preparations, etc. The kneading machine and sewing agent production equipment are unique mixing and stirring machines. It is common to use two ∑ blades and parallel circular tangent differential sorting, where one blade has a faster speed and the other has a slower speed, which is conducive to causing shear stress. Different blade speeds promote the quick cutting of the raw materials of the mixed rubber, thereby enabling the raw materials to be mixed evenly.

1. After equipment installation, carry out cleaning, decontamination, and scrubbing of rust resistant plant oils and fats. Inspect each lubrication point and introduce lubricating grease.

2. Before driving, check the tension level of the V-belt and adjust the anchor bolts to move the motor to an appropriate position.

3. Check whether the standard parts are loose, whether the steam pipeline is leaking, and whether the power circuit and electrical equipment are safe. The electric heating kneading machine must have a grounding system.

4. Clean and tidy the pre molding room before debugging. Perform 10-15 minutes of aviation component rotation, confirm that the equipment is operating normally before adding materials for production and manufacturing. Generally, the transmission gear (including reducer) of a new mobile phone produces a lot of noise during the initial application, which will naturally decrease after a period of time when it is in and out.

5. When using steam heating, valves and pressure gauges should be installed at the inlet of the steam pipeline, and the working pressure of the steam should not exceed the specified working pressure for the mixing tank indicated on the label.

6. When pre shaping the mixing paddle, it is necessary to reduce the application flipping.